Sealand MasterFlush electronic-flush toilets Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Sealand MasterFlush electronic-flush toilets. SeaLand MasterFlush electronic-flush toilets User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 1
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Dometic Touchpad Installation
for VacuFlush
®
and MasterFlush
®
electronic-flush toilets
® Registered; ™ Trademark of Dometic Corporation
© Dometic Corporation
600346526 02 11/12
2 in.
(51 mm)
0.10 in.
(2 mm)
dia.
1.375 in.
(35 mm)
2.625 in. (67 mm)
3.25 in. (83 mm)
1 in. (25 mm)
2 in. (51 mm) clearance
behind wall surface required
1. Plan touchpad location so wiring cable can
reach toilet base circuit board. Be sure cable
cannot get wet.
2. Using template (below), mark center access
and fastener holes. Drill 1 in. (25 mm) center
access hole, then fasten touchpad bracket to
wall (g.
1
).
3. Route touchpad cable through wall access
hole to oor access hole at toilet base.
4. Attach cable to back of touchpad, then snap
the touchpad onto the bracket (g.
1
).
5. WITH ELECTRICAL POWER OFF, connect
wiring cable from the touchpad to the RJ45
connector on the circuit board of the toilet
base (g.
2
).
2
1
Caution!
If replacing a different style electronic
ush switch, WITH ELECTRICAL POWER
OFF, be sure to disconnect wiring from old
switch before installing new touchpad.
Zobrazit stránku 0
1

Shrnutí obsahu

Strany 1 - Dometic Touchpad Installation

Dometic Touchpad Installationfor VacuFlush® and MasterFlush® electronic-flush toilets® Registered; ™ Trademark of Dometic Corporation© Dometic Corpor

Komentáře k této Příručce

Žádné komentáře