Sealand DVS01 VacuFlush Status Panel Uživatelský manuál stáhnout pdf (Strana 7)

6 Installation

Caution!

DonotinstallDVS01panelinareawithpotentiallyammableorexplosivevapors.

1. Select panel location away from direct contact with water and oil.

2. Conrm clearance for wire connections behind wall, hull liner or bulkhead.

3. UsingDVS01paneltemplate(g.

, p. 11), cut out panel access hole and drill fastener holes.

4. Removepanelcover(g.

1,p.2)frommountingframe(3),ifnecessary,bycarefullypullingthem

apart. Install mounting frame to wall with four fasteners.

5. Withelectricalpoweroff,routeproperwiringtoDVS01panellocation,makingsurewiresextend

outthroughaccesshole(g.

4,p.2).Refertowiringdiagrams(gs.

and

, p. 3,

g.

, p. 4) for appropriate toilet system. Make nal wiring connections.

6. Push panel cover onto mounting frame until it locks.

7. TurnonelectricalpowertoDVS01panelandtoiletsystem.Conrmnormaloperationofstatus

lights.

7 Operation

7.1 Vacuum status monitor (g.

, p. 2)

1. WhenpowerswitchisturnedON,thegreen light indicates that there is sufcient vacuum in the

VacuFlushsystemtoushthetoilet(A).

2. WhenpowerswitchisturnedONandthered light glows, this indicates that there is NOT sufcient

vacuuminthesystemtoushthetoilet(B).Do not ﬂush toilet, or blockage may occur in system.

Notes

Ifgreenandredlightconstantlycycleonandoffbetweenushes,thereisapossible

vacuumleakinthesystem.(AnidleVacuFlushsystemshouldnotcyclemorefrequently

than once every three hours.)

If green light is ON but there is no vacuum in system, a blockage has likely occurred

betweenthetoiletandvacuumtank.Openushballintoiletbowlandusestandardtoilet

plunger to unblock.

After a period of time, if red light seems to remain lit longer than when toilet system was

new,duckbillvalvesinvacuumpumpmayrequirereplacement.

Caution!

IfDVS01isconnectedtoa“fulltank”sensorandholdingtankisempty,acontinuousred

light may indicate extensive vacuum loss due to blockage, pump failure or leak. Turn off

vacuum system and repair as soon as possible.

7.2 “Full tank” monitor (whenconnectedto“fulltank”sensorinwasteholdingtank)

WhenpowerswitchisturnedON,theredlightglows,andthevacuumpumpisnotrunning,this

indicates that the holding tank is full and needs to be pumped out. Do not ﬂush toilet, or blockage may

occur in system.

SeaLand DVS01 Panel Specifications

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Sealand DVS01 VacuFlush Status Panel Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Hardware Sealand DVS01 VacuFlush Status Panel