Sealand DTM04 Tank Monitor System Manual Uživatelský manuál stáhnout pdf (Strana 10)

Dometic Tank Monitor SystemInstallation

6.4 Key to DTM04 system wiring

(g.4,page3)

Ref. Description

A DTM04indicatorpanel

B Wastewater tank

C 12VDC

D 24VDC

E VDCground

F 1-amp circuit breaker or fuse

G Red

H Blue

I Black

J Green

K Yellow

L Orange

M Full level probe

Ref. Description

N Mid level probe

O Low/Emptylevelprobe

P 12or24VDC

Q Toilet system circuit breaker or fuse

R +VDCtoelectrictoiletsystem

S +VDCto“fulltank”monitor(optional)

Notes:

1. Heavy line indicates 14 gauge or larger stranded

copperwireisrequired.

2. Other wire can be 18 gauge stranded copper wire

or larger.

Caution!

Operator must know local regulations for emptying a holding tank.

Caution!

Do not install probe cap in fuel tank. NeverinstallDometicprobecapwithoatswitches

into a tank that contains anything other than waste water, grey water or fresh water.

6.3 Probe Cap (g.3B,page2)

1. Loosen compression nuts on adjustable probes and install probe cap into tank. Following

numbersprintedontopofprobecap,slidethe“1”probe(g.3B4,page3)downuntilthe

oattouchesthebottomofthetank.Tighten“1”compressionnutandmarktheprobetubeat

the top of the nut. Do not cut the probe tube at this mark. Loosen the compression nut, slide

theprobeup,andcarefullycutthe“1”probetube42mm(1.625inches)belowthemarkwithout

damaging the wires inside the tube. Pull the wires through the black wire cover and push the

probe down into the compression nut until the black wire cover touches the compression nut.

Therecessedshoulderoftheoat,ortheletters“NO”,shouldbefacingdown(B5).

2. Removeprobecapfromtankandadjustthe“2”probe(g.3B6,page3)forone-halffulllevel

for black or gray water tanks. Tighten the compression nut and cut the probe tube off 10 mm

(0.375inch)abovethecompressionnutwithoutdamagingthewires.Sliptheblackwirecover

ontothetopofthetube.Therecessedshoulderoftheoat,ortheletters“NO”,shouldbefacing

up(B7).

3. Route18-gaugestrandedcopperwiresfrommonitorpanelandDCgroundsourcetotheprobe

cap.Usequick-disconnectterminalsonoatswitchwirestopreventtwistingwireswhenremov-

ing the cap. With cap removed from tank, connect the wires according to the wiring diagram

(g.4,page3),turnonelectricalpowertosystem,andtesttheoatsbymovingthemupand

downandmonitoringtheDTM04panel.DisconnectthewiresandinstalltheprobecapandO-

ring into the tank. Reconnect the wires.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 71 72

Komentáře k této Příručce

Žádné komentáře

Sealand DTM04 Tank Monitor System Manual Uživatelský manuál Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Hardware Sealand DTM04 Tank Monitor System Manual